Great … thanks … label # works now …. I have the confirm multi checked … still only one per … looks like there is room for

at least 3 qso’s.? It knows there are 2 qso’s because it prints ?2 labels and each says “cfms a 2x qso” on top.

john

?

Sent from for Windows 10

?

---

From: [email protected] <[email protected]> on behalf of ND9G Mike <mike.nd9g@...>
Sent: Tuesday, March 26, 2019 9:07:55 AM
To: [email protected]
Subject: Re: [DXLab] labels

?

John,

1. In the QSL config dialog, on the General tab, is the Confirm multiple QSOs per QSL box checked?

2. When your QSL queue is set to one of the label options, in the far lower left is a text box where you can enter the number of labels to skip, default is 0 for a new sheet.

73,

Mike ND9G

On Tue, Mar 26, 2019 at 9:02 AM John Battin <jbattin@...> wrote:

I can not figure out how to:

1. Have more than one qso per label
2. Start printing at any other position than 1. Before I print it asks “ok to skip 0 labels?? - but can not tell it no – start here..

John k9dx

?

Sent from for Windows 10

?

---

From: [email protected] <[email protected]> on behalf of Dave AA6YQ <aa6yq@...>
Sent: Saturday, March 23, 2019 3:59:38 PM
To: [email protected]
Subject: Re: [DXLab] labels

?

+ AA6YQ comments below

It is Avery 94202 1"x4".? Also tried blank and also the default # (can not recall it right now).? The results seem identical no
matter what settings I use. the colums are too small and the info overlaps into the next cell.? You may have it ... the font may be
too big. I have not seen a setting for that.

+ There are four Font panels in the lower have of the "QSL Labels" tab of DXKeeper's "QSL Configuration" window. Set them all to 7,
check and print preview, and then increase the font size for the elements as desired.

?????? 73,

?????????? Dave, AA6YQ