开云体育

Tried, same result, in Chinese.

You're funny.

try this software

Have you tried adjusting the volume of the radio? Too loud or too quiet and it will not sync.

More info... I installed the CPS from the Radioddity site and it also does not work. Settings -> Port COM1 Program -> Read form radio Click Start "hand shake..." "failure!" My gut feeling is that the

First post here, hello. I was gifted a UV-5RX3 and I am unable to get CHIRP (next) to read it. I have selected the Radioddity UV-5RX3 model and the correct com ports - which is either a real Serial

Eddie, Squelch on my Baofengs are all set for 2. Otherwise, you may be between a rock and a hard place.? I've had nothing but trouble with Chirp.? I'd say keep looking on RT Systems almost daily

I have a quick question for the group. I have purchased a Baofeng VU16 Pro (Dual Band model). Somehow I have overwritten the base file I had saved when I got the radio before I started programming it

Thanks, Bob. A1) Yes, I can hear the repeater with tone turned off. A2) Yes, there is a nearby uncoordinated repeater on the same frequency that often breaks squelch but is weak signal and

You have said that you can't hear a repeater that transmits a ctcss tone when you have the ctcss receive turned on. Q 1) can you hear the same repeater without the ctcss receive turned on? Q2) if

I have one that works just fine.? I use the RT Systems programmer for it, as I do on nearly all of my radios. ?Dave Springer, N0TXJ Get BlueMail for Android ?

Hi Donald: I'll second that. In 2012 I got my Technician's license and bought a UV-5R as my first amateur radio. After setting it up and programming all the local repeaters, I found I could hear

Rich . . . wrote: With the type of issue you are having, I would not recommend buying RT Systems software because I doubt you'll get different results. Of course, you can try, but I'd be surprised if

Thanks for the replies. I have loaded the UV-5rx software and it reads and writes to the radio properly. When I use the software to read the radio Frequency Range setting, it read the setting which is

If You Are able to program them via using a "Chirp File" no Need to spend $ on RT,? If Memory Serves Me, The OV-S9X3 Needs to have the the 220 band "Activated" via a check box process using , I Dd a

Dave . . . <n0txj@...> wrote: While I never had issues with CHIRP, RT Systems software is a bit more refined. They also work hard to support other models that CHIRP doesn't support. I

I have had multiple issues using Chirp.? Spend a few bucks and go with RT Systems, especially if you are programming "a bunch" of them.? I've never had an issue one with RT Systems and have used

Our club has bulk purchased a bunch of Baofeng UV-S9X3 to sell or give away to new hams. The UV-S9X3 is a tri-band radio that makes a great introductory radio. We have a Chirp file we use to program

Has anyone else tried to use a CTCSS receive tone on their BF-F8HP?? If I have a transmit CTCSS tone configured, I cannot make a receive tone "stick".? That is, when I exit the menu, the setting

Hi Donald; Thanks! I finally solved the programming issue this morning. Stopped trying to use CHIRP-Next and used CHIRP-Legacy. Now no problem programming/reprogramming my UV-9R PROs HTs with CHIRP.