Added the following at line 748 of :
? ? ? ? ? ? SetRF_OutAtten(adjuster);
The version on GitHub should be able to set the TX attenuation now -- can't test it myself unfortunately.
On Monday, April 14th, 2025 at 2:56 PM, Oliver KI3P via groups.io <oliver@...> wrote:
I'm away from my radio at the moment. Can someone with a working radio confirm that this affects them too? Will take a look at the code tonight and see if I can find anything obvious.
-------- Original Message --------
On 4/14/25 1:33 PM, K9HZ wrote:
Good question¡ the TX attenuator should work the same way¡ so either there is a bug in the software¡ or there is a problem with the MCP23017. Since the RX side works I think its probably a bug in the code. Oliver will know.
?
?
Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ
?
Owner - Operator
Big Signal Ranch ¨C K9ZC
Staunton, Illinois
?
Owner ¨C Operator
Villa Grand Piton ¨C J68HZ
Soufriere, St. Lucia W.I.
Rent it:
?
Moderator: North American QRO Group at Groups.IO.
Moderator: Amateur Radio Builders Group at Groups.IO.
?
email:? bill@...
?
?
?
V12.6 RF board. 'Menu/RF Set/RF in Atten' works fine, I get the appropriate 3.3v at pins 21 - 26 as adjustments are made. But 'RF Out Atten' doesn't work the same. I don't see any voltage on pins 1 - 6 as adjustments are made. What am I missing?
