Re: CNCZEUS is now Open source
|
I just tried downloading CNCZeus from GitHub, and all that's there is the source code. ?Does anyone know if there's an executable available for download, or do I need to buy a $100 compiler just to try it out?
Thanks.
From: "Warren LeMay notebook@... [7x12minilathe]" <7x12minilathe@...>
To: 7x12minilathe@...
Sent: Saturday, July 29, 2017 4:41 AM
Subject: Re: [7x12minilathe] CNCZEUS is now Open source
?
I'm not sure where the below email was, but it is 12 hours later,
I just got up, and it arrived here at 4:38 AM.
Yahoo Magic??
Warren L
On 7/28/2017 4:31 PM, Warren LeMay
notebook@... [7x12minilathe] wrote:
blow it....? I think Chris authored it...? Beat me up if
I mess this up Chris... (on or offline)
In the US, those applications that run on MS-DOS are
considered a bit barbaric and lacking in sophistication.?
The one thing that Chris and I do differ on is that MS-DOS
is pretty much the original
[snipped]
|
