¿ªÔÆÌåÓý

Re: LMS 4700 mill


 

¿ªÔÆÌåÓý

Does it move when you have the Z axis lock lever on the left side of the column locked down??? Unless you are really using this in the "drill press" mode, that should be locked after the cutter depth is set.

Does the cutter move, or does just the knob move??

On the X-2, the knob will move within the slack zone, and it is important to take up the slack before unlocking the Z axis.? However, with the Z axis locked, the tool itself does not move.

I dont like the sloppiness of the X-2, so I work with an indicator on the Z axis to measure/set depth.

Warren L


On 7/25/2017 10:12 AM, 'Johannes' johannes@... [7x12minilathe] wrote:

?

?

This is the fine-adjuster to LMS 4700 Mill.

Have somebody made a lock for this?

?

My adjuster is moving (turning) when I am milling, and before I am doing something stupid, I want an advice from you.

?

Best regards

Johannes

?


Virus-free.

Join [email protected] to automatically receive all group messages.