Re: seperating workpiece cyno
|
Soak in a covered jar of acetone.
If that does not work,try a heat gun,it will soften,and if hotter,will burn off.
|
--- On Thu, 2/7/13, zl1atb wrote:
From: zl1atb
Subject: [7x12minilathe] seperating workpiece cyno
To: 7x12minilathe@...
Date: Thursday, February 7, 2013, 3:23 AM
?
I saw a few weeks back guys using cyno superglue to attach small pieces to dress them up,someone was turning both sides of a narrow washer, I cant remember how to seperate the turned piece.
I glued some 2 inch ali bar it held good , now ?its still held good .
I tried hitting it with a plastic mallet , wondering If I should soak it, hoping the cyno will break down.
Don
|
maschwiebert