hello all memebers
I have the "Einhell mtb 300" minilathe
with a KBLC-240d controll board
I turned very slowly ,and did make the lathe stall..
Then It would not run anymore...
Each time I turn the speed controller to off.. and turning on again, the chuck moves a few centimeters.. trying in reverse gave the same result.
I did not think I had overloaded the regulator ,so I tried to find the reason.. with the pot ,that connect when off, in mind, I looked at this switch..
it is the switch that are defective.. it sometimes make contact and sometimes are not effectiv closed.. it often make a short short when I turn on the speedcontroller.
Well no need to examine how and why.. the switch in the speed control is not good anymore.
Then I looked at ARC in UK for buying a new one.. they have them , but it is out of stock.
finally.. hope someone sometime can use this mail ,if he have the same problem and
second.. Do any of you know of another supplier here in Europe
thanks for listening
alex
Denmark
