--- In 7x12minilathe@..., Jerry Smith <jfsmith@a...>
wrote:
Mike,
I got the 5 inch chuck from Enco for my 7 x10, it's about
$60 and
I have never put the factory three inch on back on.
Jerry
At 04:52 PM 7/25/2003, you wrote:
i have 7 x 12 lathe similar to the homeir. I need a chuck with
jaws
slightly larger than the standard chuck supplied. Can you just get
bigger jaws?? Who is the best (least expensive) source for a
larger
chuck if that is the way to go? How do I make sure it will fit my
lathe??
thanks
mike aita
did you need a backing plate for this
thanks
mike
