I can see why "quality of light" would matter to someone matching colors or
something, but why does it matter to machining? My shop is all CF bulbs,
except one incandescent bulb near the lathe because I sometimes use it as a
source of heat. (In fact, my whole house is CF bulbs except for one on my
desk that my cat likes to sit under, again as a source of heat).
Mike Taglieri miket_nyc@...
Everyone has his reasons.
- Jean Renoir "The Rules of the Game"
toggle quoted message
Show quoted text
----- Original Message ----- > On 09/26/2011 05:02 PM, Andrew wrote:
They phased out the 'normal" incandescent bulbs in Australia. The only
decent alternative are halogen type. I found the CF give a lot of light
but not the right type of light. Even the "warm" version did not seem to
be the right quality of light.
