Re: shaft and bushing for the B/C change gears
|
Hi,
You could try gently heating the stud/gear combination in the hopes that the thermal expansion will break the bond.
Ian.
|
--- On Sun, 9/10/11, jaspercan7 wrote:
From: jaspercan7
Subject: [7x12minilathe] Re: shaft and bushing for the B/C change gears
To: 7x12minilathe@...
Date: Sunday, 9 October, 2011, 17:47
?
I should be more specific. In addition to suggestions to keep it from happening again, are there any recommendations for non-destructive ways of separating the stuck bushing from the shaft?
--- In 7x12minilathe@..., Jerry Durand wrote:
>
> polish shaft and use more lithium grease?
>
> On 10/09/2011 09:17 AM, jaspercan7 wrote:
> > I was doing some general turning under power feed yesterday, nothing elaborate, and all of a sudden the lathe stalled. After much investigation I finally diagnosed the problem: the B/C gear bushing has somehow fused or stuck itself to the B/C gear shaft on which it rides. Seems absolutely welded. Right now I have it soaking in wd40.
> > Anyone had a similar problem and can give any advice?
> > Thanks,
> > Paul
> >
> >
>
> --
> Jerry Durand, Durand Interstellar, Inc. www.interstellar.com
> tel: +1 408 356-3886, USA toll free: 1 866 356-3886
> Skype: jerrydurand
>
|
