Good morning guys,
I'm a little lost here.
When I'm parting off a piece and I move the crosslide into the work, the cutter rides, I guess, downward then "pops" up. The bottom of the crosslide doesn't seem to be moving, but either the compound or the tool post does move. I checked and the toolpost seems to be tight to the compound. Which leads me to believe the compound is loose. Where do ZI tighten this?
It turned into a major problem because I was making a ferrule for a fly rod and the piece got all bent to heck and is now completely unusable.
Thank you,
Ren
