hello, seems like a few of us got a new machine this week. just a note
to them. I thought a neat little thing to start with would be a mt3
fly cutter, so i looked up the dems, set the compound to 5 and started
cutting. must have done that wrong too cause mine don't make chips.
just tiny fine curls. anyway the mt3 don't fit. looked it up again and
sure enuf, it says 5. what it don't say is that it's 5 total. not 5
from center line. an old hand could have spotted that right off, but
that's OK. I can start a fire with just a couple of sticks.
fri...
