Doh ..... Do I look as stupid as I feel? I figured it out late last night.
Bill
On 3/13/07, andrew franks <andyf1108@...> wrote:
Bill, I know this sounds a bit obvious, but are you sure that, if
there's a hinged chuck guard fitted, it's lowered? If not, lower it, press
the green button to reset the safety switch, and try again!
Andy
Bill <billcnc@... <billcnc%40gmail.com>> wrote:
Hello All,
I just drove two 3 different HF stores and bought the 7x10 mini lathe.
I take her home all proud and I pull it out of the box and she looks
GREAT! I then start wiping the red pain in the #%@ grease off of it.
Takes an hour or so to get it all off and rub her out. I plug her in
and start up the motor first in low for a few seconds and I turn the
speed knob to see the speed. I then put it in high gear and turn her
on and turn it up to see the speed there for a few seconds. Then I
went to try her in low gear and .... NOTHING!
The fuse is good the lighted switch is lit up, what could it be? I
have removed the cover to look inside at the wires, all looks good. I
cant smell anything so I know nothing smoked. I have the4 speed
adjustment knob off before I start like the manual say to do. still
... NOTHING!
Any Clues?
Bill
---------------------------------
All New Yahoo! Mail � Tired of unwanted email come-ons? Let our SpamGuard
protect you.
[Non-text portions of this message have been removed]
