--Hi Pete,
Not sure where you can get fuses, other than micro mark or LMS, but
they're probably available. What I wanted to say though, is you
might want to consider changing the fuse holder to a better one that
takes standard size fuses. I had problems with my lathe shutting off
occaisionally, and traced it to the fuse holder. It had actually
split in half! It's a real piece of junk! I put in a standard one of
much higher quality and the fuse issue was solved. To me the stock
one is so bad, it could almost be dangerous! Good luck.
Frank
- In 7x12minilathe@..., "Pete Lilja" <plilja@...> wrote:
Uh-Oh, I was finally playing with my newly purchased used Micro-
Mark 7 x 14 and popped a fuse. No big deal, methinks, and I stopped
at the local Ace Hardware to get another. Much to my chagrine they
didn't have a similarly sized fuse.
So, what is the deal on these fuses? Are they a rare find or can
I get them locally?
Thanks,
Pete
