First let me say thank you for all of your input..
Now I have just one more question for you all. at least one more till
I actually get my Lathe.
If money was not a big deal, what mini lathe would you most like to
own? and why?
ok two questions.
I dont mean to be a pest or to monopolize the conversation, I just
like to be sure before I buy a tool that I am going to get the most
use out of it I can...
Thank you for your patience and advice, they are both apprieciated.
lokinb
--- In 7x12minilathe@..., "Brice D. Hornback" <bdh@c...>
wrote:
The "Speedway" is the Homier 7x12.
- Brice
----- Original Message -----
From: <lokinb@y...>
To: <7x12minilathe@...>
Sent: Thursday, December 26, 2002 5:01 PM
Subject: [7x12minilathe] speed way 7X12
Hi again
I found an auction on ebay for the 7X12 mini bench lathe made by
speed way.
ViewItem&item=3102472367&category=25288
Is tis a good choice at only 300.00 dolars I am not sure and would
hate to buy it and have to buy another 6 months later cause it
wont
do all the things I want.
basically I want the lathe to do all the things a large lathe can
just on a smaller scale.
turning theads on the outside as well as on the inside of a piece.
shapeing and cutting.
any input you can give as to the suitability of this unit would be
greatly appreciated.
thanks
Lokinb
To unsubscribe from this group, send an email to:
7x12minilathe-unsubscribe@...
Your use of Yahoo! Groups is subject to
