ya could pull the motor & hook a volt meter to the leads
& spin it with a drill & see if ya get any voltage out .
I'd try to see if it spins with a tool battery first .
animal
On 6/12/24 7:53 PM, Arthur Coe wrote:
toggle quoted message
Show quoted text
Yes, that's the lathe.?
Pulled the brushes and they are both about an inch long - I'm
assuming it is not the brushes.
On Wednesday, June 12, 2024 at 06:56:57 PM PDT, mike
allen
<animal@...> wrote:
? ??? Is this the lathe?
see page 39
??? animal
On
6/12/24 6:18 PM, Arthur Coe wrote:
Had a crash awhile back while using a milling bit on
my Grizzly 7x12 mini lathe.? Motor stalled and fuse
blew.? I put in a new fuse, but motor won't run.? Are
there any other circuit breakers/fuses that could be the
problem?? Or, am I looking at a blown motor?
