Re: 3-jaw largest bore?
|
I too have collets, but I also purchased a 4 inch 3 jaw from little machine shop that I mostle use. Regards, John Mattis (retired mechanical engineer On Sat, Jun 1, 2024 at 4:28?PM John Los via <iron2old=[email protected]> wrote: I bored my 3" chuck out to 3/4". I no longer use the chuck very often, as I do most of my work with collets now.? Looks like 13/16" would work, but it looks like you would cut into the heads of the 3 little screws the hold the plastic disk in the back of the chuck.? ----- John |
John Mattis