Re: Holes in cast iron
|
It would better to see for photos for right recommendation.?
toggle quoted message
Show quoted text
If cast iron jaws or location the typical the cast is about 25,000psi.? If steel it could go a lot high to 100,000 psi a different problem and fluxcore/mig is a good option.? Brazing is can also be good some rods are 67,000 psi that rod I use for repairs. The down side is you can see the color of brass.? If restoring fof some else the may want the same or very close color . If cast iron this a real pain the fine righ color of rod. The cast iron welding is very higher skill need.? Dave? chrisser Feb 22? ? I inherited a nice little used milling vise from my Dad. It's been sitting on a shelf for a bit waiting for me to clean it up and put it to use. There's a couple spots where it looks like someone missed with a drill and drilled slightly into the tops of the jaws |
davesmith1800