On Sun, Apr 3, 2022 at 04:12 AM, paul mcclintic wrote:
The one I am trying to get them to correct is the taper of the spindle. When I placed a dead center in it I have 0.0035" run-out which is unacceptable by most standards.
Your comment inspired me to add that to my 'ToDo' list for my Vevor. :) I know that the open end of the spindle bore is almost perfect (<0.01 mm runout), but I don't think I have a way to reach very far into the taper to make measurements.
How did you measure the runout? I don't have a lot of confidence in the MT centers and adapters I have.
