thanks for all the feedback.? I'll take it apart soon to check all the gear teeth and come up with some ways to minimize any slop.? If I find the forward/reverse lever detent divots aren't in the ideal spot, what is a good way to correct it?? Fill in the divots by welding and create new divots?? I 'm assuming the divots will be close and I won't be able to drill an entirely new hole... any new hole will be partially on top of the old.? I haven't looked at this at all so I'm only making some assumptions.?
On Sun, Mar 27, 2022 at 9:04 PM j_r_abercrombie via <j_r_abercrombie=
[email protected]> wrote:
On Sun, Mar 27, 2022 at 05:58 PM, Roy wrote:
Use a small strip of paper, caught in the gear mesh, to set the spacing before locking the sliding pivots.
Thanks. I'll use that paper trick next time.
