Re: Mini lathe gear noise
|
Aside from what you already mentioned, check the engagement of the gear¡¯s teeth for backlash. You can use a plain piece of copier paper between the teeth of two gears. ? Many times there is more than one set of gears that will give you the same pitch. You could try using some other gear selections. ? Michael - California, USA Micro-Mark MicroLux 7x16 LMS 3990 Hi-Torque Mill with power feed ? ?
toggle quoted message
Show quoted text
From: [email protected] < [email protected]> On Behalf Of Chad Rebuck Sent: Saturday, March 26, 2022 10:26 AM To: [email protected]Subject: [7x12MiniLathe] Mini lathe gear noise ? I was needing to engage the feed gears to cut some threads and in the reverse? direction to feed away from the chuck it sounds bad.? It gets to a point where it vibrates awful.? I didn't want to take too much apart at the moment but I can't exactly see what the problem is.? Are there a common things to check with the gears?? The gear slot seems to be adjusted pretty well.? The vibration is definitely coming from where the small two gears contact the gear right below it. Any suggestions?? Maybe a worn bushing or too much side to side clearance on a shaft where the gear is mounted? ? On Fri, Mar 25, 2022, 1:09 AM Bill Williams <BWMSBLDR1@...> wrote: While I have your USPS address I have lost your E-mail address. Just to let you know that your Atlas 618 compound has been packaged to withstand the rigors of a trip through the post office and is leaving for Kansas tomorrow! Sorry for the delay. Keep your eyes open as transit times can vary from 3 days to a week. Let me know if and when it arrives safely!?? ??????????????????????????????????????????????? Bill in Boulder CO
|
