¿ªÔÆÌåÓýThe control board not only changes 120V to 230V, but it makes it 3-phase too. The marvel of electronics, which I do not understand. ? The Fault light indicates an error condition. In your case it may be because the motor is not giving reliable feedback of its speed. ? Chris ? From: [email protected] <[email protected]>
On Behalf Of Johannes via groups.io
Sent: Tuesday, March 22, 2022 4:49 PM To: [email protected] Subject: Re: [7x12MiniLathe] LMS 5200 Lathe motor ? Hi Chris Nice you are following us on the Group. I have an electrical question: how do you make ?120 V to a 220 V motor?? (Just for education!) ? The 5200 lathe lamps is for 220 V, so it is difficult to read, but easy to fix. To day with my broken motor, I see the FAULT lamp is glowing a littlebit. Can you explain FAULT error ? ? /Johannes ? ? ? ? Sendt fr? for Windows ? Fr?:Chris Wood ? The motors used on the LittleMachineShop.com mini lathes and mini mills are 230V motors. ? The motor on Alibaba is a 48V motor. Besides the voltage being correct, be sure to check the physical dimensions. ? SIEG makes those motors at their factory in Shanghai so they may not be standard. ? Chris Wood ? ? ? ? From: [email protected] <[email protected]>
On Behalf Of Michael Jablonski via groups.io ? I was looking into getting one of these motors for another project a while ago and found this: < > ? I¡¯m not sure if it will work, and I did not buy one yet but thought I¡¯d pass this on to you as a possibility. ? I wasn¡¯t happy with the replacement cost from either Micro-Mark or LMS. ? Michael - California, USA Micro-Mark MicroLux 7x16 LMS 3990 Hi-Torque Mill with power feed ? ? ? From: [email protected] <[email protected]>
On Behalf Of Johannes ? Hi group ? I have a 5200 LMS lathe, and I think the motor is gone. It need a manual twist ?to run and the motor make a lot of noise. ? Sometimes ago the motor make a lot of noise, and I took out the rotor. The axel under the bearing was very worn, I did something and it has worked ok until today. ? A new LMS 4145? 500 Watt Brushless DC motor will cost me 350/400 USD. So before I order, I ask my group : is it possible to get a new motor that can replace and fit to my 5200 lathe ? ? 350/400 USD Is nearly 1/3 of a new lathe? :-) ? If someone have some experience with this motor or similar , you are welcome to give me some advice. ? Best regards Johannes Mexico ? ? ? ? |
