Ralph,
How do you like the motor performance?
Do you have continuous (0%-100%) analog speed control? What did
you do for your mounts and belt drive interfaces?
.
I was looking at this pretty closely
.
.
TIA for your thoughts
On 3/22/2022 8:47 PM, Ralph Hulslander
wrote:
toggle quoted message
Show quoted text
I have the hp motor on
my lathe, my mill and my bandsaw and I have a spare.
Ralph
On Tue, Mar 22, 2022 at 8:16
PM mike allen <
animal@...>
wrote:
??? ??? if you don't mind making a new motor mount you
can use a treadmill motor & controller , that will
give you variable speed .
??? ??? animal
On 3/22/2022 3:23 PM, Johannes wrote:
Hi group
?
I have a 5200
LMS lathe, and I think the motor is gone.
It need a manual
twist ?to run and the motor make a lot of noise.
?
Sometimes ago
the motor make a lot of noise, and I took out the
rotor.
The axel under
the bearing was very worn, I did something and it
has worked ok until today.
?
A new LMS 4145?
500 Watt Brushless DC motor
will cost me 350/400 USD.
So before I
order, I ask my group :
is it
possible to get a new motor that can replace and
fit to my 5200 lathe ?
?
350/400 USD Is
nearly 1/3 of a new lathe? :-)
?
If someone have
some experience with this motor or similar , you are
welcome to give me some advice.
?
Best regards
Johannes
Mexico
?
?
?
