The mini-mill group is pretty much dead, so it's fine with me to ask milling questions here.? Most of us do milling here anyway, on our lathes if we don't have mills.
On Fri, Jan 21, 2022, 10:24 AM Ralph Hulslander <rhulslander@...> wrote:
Strange that you asked this on a Mini Lathe group.
I had a discussion last year about doing exactly this turn out getting a large 90¡ã angle piece to mount the rotary table to?
was the best solution.
Of course this is a pain if you want to use the table horizontally as it has to be unbolted from the angle piece.?
Ralph
On Fri, Jan 21, 2022 at 10:14 AM fxkl47BF via <fxkl47BF=[email protected]> wrote:
I recently acquired a Palmgren 800 rotary table for a faction of this cost.
I would like to modify it to mount horizontally or vertically on a small mill.
I'm open to suggestion before I start hacking.
Thanks