Re: Rong Fu Industrial Introduction
|
Sometimes I wonder, if some reverse engineer from photographs, rather than by actually having a machine to disassemble, measure, and clone.
?
I have a thin angle jaw I made for my Grizz saw, to cut pieces wider than 6¡±, actually, almost 7¡±. I¡¯m going to build a spacer for the fixed jaw, and I¡¯ll be close to 8¡±.
Just one of some little doo-dads I have built to expand the capabilities of the saw.
Necessity ya know!
J
?
Bill
?
?
toggle quoted message
Show quoted text
From: [email protected] [mailto:[email protected]]
On Behalf Of Jerry Durand
Sent: Wednesday, April 29, 2020 8:35 AM
To: [email protected]
Subject: Re: [4x6bandsaw] Rong Fu Industrial Introduction
?
It was other brand, I should have bought RF.? With a 3x6 tube the left guide hit the tube and prevented cutting.? Pictures attached.
Many Chinese products suffer from making something that looks like the competition but the lower quality factories may not understand what each part of the product is for.? In this case, the fixed jaw of the vice was too far into the cutting area and made of
very thick cast iron.
I fixed it by replacing the vice jaw with thin angle.
On 4/29/20 4:53 AM, RF-Henry wrote:
Hi, Jerry:
How come 4x6 can't cut 3x6? I am not sure if it is happening on other brand, maybe this is their weak point.we have to study the one HF saw inside out factory.?
--
Jerry Durand, Durand Interstellar, Inc. +1 408-356-3886
&
?
|
