?
Hi there group, ?I just picked up a nice little
super in good shape Grizzly G1010 4x6 from a lady
whose husband passed away. ?Got it super cheap.. ?He
was a wood worker and used it to cut wood only. ?The
saw is complete and was kept covered when not in use.
?The only thing that was disassembled was the two
guide bearing assemblies. ?I purchased 6 new 6000z
bearing and installed them on the shafts and saw that
two of them were concentric for adjustment. ?My
question to anyone who can help is where do they go?
If
you are standing in front of the machine looking at
the Grizzly nameplate on the left and motor is on the
right in horizontal cutting position. ?Do they go in
front of the blade or behind? ?Or does one guide get
one on the front and the other guide get one on the
rear of the blade? ?I¡¯m stumped?????? ??Need some help
getting this little metal slicer up and running!!!!
? One on each end , put them both on the same side of the
blade . Then adjust for about .006 - .010 chip clearance between
the blade and guide bearings . There are a couple of good
articles on alignment in the archives unless yahoo has managed
to lose them .
? To the group owner - have you considered moving the group
to IO ? Several other groups I read have made the move , and are
better for it .
? --
? Snag
