开云体育

Christopher, You get your radio back to default parameters. Maybe there is a setting that you made and forgot which one is. Let me know if solved with that step 73’s de Enzo IK8OZV Inviato da iPhone

Vincenzo, What does a Full-Reset ential? Thank you for your time. Christopher

Christopher, Apologies for the stupid question. Have you tried to do a full reset of the radio? If not try. 73’s de Enzo IK8OZV Inviato da iPhone

Mine does that in AM mode because I don't have that filter installed. Regards, Steve KA8HKC wrote:

Vincenzo, The ERROR msg, has nothing assigned to it. Just ERROR pops up in the display? This only occurs on transmit; CW/SSB both modes come up with the *ERROR *in the display. Kind regards,

Tom, Yes on the ham radio frequency(s), all bands/frequencies exhibit the same ERROR msg. CW or SSB, both modes? Kind regards, Christopher

Which error message you get???? 73 de Enzo IK8OZV EasyLog 5 BetaTester EasyLog PDA BetaTester WinBollet BetaTester D.C.I. CheckPoint Regione Campania Skype: ik8ozv8520 *** * GSM +39 328 7110193

Hi Christopher, I'm not near my FT-920, so I'll just toss the question out there: Are you by chance operating on an amateur radio frequency? Tom

My FT-920 displays an ERROR message whenever the mic or key is activated? I cannot find anything in the instruction manual that address this message? Christopher

I acquired an Astatic D-104 mic with the T-UP9 base. I wired it up to an eight pin mic connector per the Astatic website directions, however the mic drive is very sensitive. When I apply a little

From time to time I experience power cycling on/off when transmitting using WSJT-X.? I mostly run 6 meters using FT8 & MSK441.? The transmit sequence starts fine and the things will start cycling on

From time to time I experience power cycling on/off when transmitting using WSJT-X.? I mostly run 6 meters using FT8 & MSK441.? The transmit sequence starts fine and the things will start cycling on

Congrads! You're a General now. Mike

Could be the AF-DSP board. Had a similar problem til the DSP board completely failed. Luckily I found a parts radio and my 920 is back on the air. Mike KA2FIR

Are you using VOX to key the radio instead of PTT? Mike

Hi All, Please apologize for the stupid question. I own a Yaesu FT-920 and an Amplifier RM BLA-350. On the back of the Amplifier I have two RCA connectors named ALC and PTT I would like know which are

Hello Folks, I hope in an help. I am using the FT-920 with a KAM Kantronics TNC from a while for digital signals. Today I have noticed a strange behaviour, when the KAM goes in TX the radio Normally

hello my problem is just ignition, sometimes I turn on and the radio remains silent, no sound is heard and it does not work in transmission, I turn off and turn on and everything has been working for

Francesco, and the group - I also have a strange action when I turn on my FT-920. More times than not, the frequency display will just flash on and off. But I have also had it come on normally with no

Hi I have a problem on the ft-920 sometimes when I turn on the radio, it is silent without sound, turned off and turning back again and everything comes back to normal where it could be the problem