开云体育

Congrads! You're a General now. Mike

From time to time I experience power cycling on/off when transmitting using WSJT-X.? I mostly run 6 meters using FT8 & MSK441.? The transmit sequence starts fine and the things will start cycling on

From time to time I experience power cycling on/off when transmitting using WSJT-X.? I mostly run 6 meters using FT8 & MSK441.? The transmit sequence starts fine and the things will start cycling on

I acquired an Astatic D-104 mic with the T-UP9 base. I wired it up to an eight pin mic connector per the Astatic website directions, however the mic drive is very sensitive. When I apply a little

My FT-920 displays an ERROR message whenever the mic or key is activated? I cannot find anything in the instruction manual that address this message? Christopher

Hi Christopher, I'm not near my FT-920, so I'll just toss the question out there: Are you by chance operating on an amateur radio frequency? Tom

Which error message you get???? 73 de Enzo IK8OZV EasyLog 5 BetaTester EasyLog PDA BetaTester WinBollet BetaTester D.C.I. CheckPoint Regione Campania Skype: ik8ozv8520 *** * GSM +39 328 7110193

Tom, Yes on the ham radio frequency(s), all bands/frequencies exhibit the same ERROR msg. CW or SSB, both modes? Kind regards, Christopher

Vincenzo, The ERROR msg, has nothing assigned to it. Just ERROR pops up in the display? This only occurs on transmit; CW/SSB both modes come up with the *ERROR *in the display. Kind regards,

Mine does that in AM mode because I don't have that filter installed. Regards, Steve KA8HKC wrote:

Christopher, Apologies for the stupid question. Have you tried to do a full reset of the radio? If not try. 73’s de Enzo IK8OZV Inviato da iPhone

Vincenzo, What does a Full-Reset ential? Thank you for your time. Christopher

Christopher, You get your radio back to default parameters. Maybe there is a setting that you made and forgot which one is. Let me know if solved with that step 73’s de Enzo IK8OZV Inviato da iPhone

I performed all of the resets, to no avail; then a hard-reset, still getting the ERROR message...sigh! Not sure where to go from here? The instruction manual provides nothing that I can use in-order

The radio receives just fine, but when I try to transmit, an ERROR message shows up in the display, preventing the radio from transmitting. SSB, or MOX, the ERROR diagnostic message appears. I have

Check the memory battery if below 3v replace it. Very common issue with this radio GENE MITCHELL. Kc0mqg

Unfortunately, I have not been able to get the ERROR message resolved. At this point, I am seeking suggestions for YAESU repair tech, and/or company that works on this particular radio. Thank you in

Greetings, My 920 will not transmit in DATA-USB. It will xmit in all other data modes as well as USB phone. It acts like it wants to transmit as the receiver switches off and the 'TRANSMIT' indicator

Duane, My 920 will not transmit in any mode. A message ERROR shows up in the display. It receives just fine, but not xmit. I also did all of the reset(s) including changing the battery...nothing

Could be a internal tuner issue there bad about it see if it will transmitt with the internal tuner off. But if you really are just done with it lmk how much you want for it I have several and could