开云体育

Dave The CW oscilator is located at IF Unit (PB-1436B). See the Fig 15 on the instruction manual. Emerson PP6EW Em seg., 25 de out. de 2021 às 14:29, Dave smith <dave.goathland@...> escreveu:

Hi Dave, The FT301 uses a separate 8999.3kHz crystal?for transmission, you?ll find it as X401 in the IF Unit (PB1436B): Schematic: Page 16, figure 15 /?Description: Page 19 CW adjustment: THIS

Thank you Gene and Carlos….My wife is out tomorrow so I shall have another go at the set. Dave…G4DAX.

Try adjusting the Carrier Level. The speech Processor might also need to be ON. Gene N4FZ

Hi Folks….I am well on the way to getting my bargain 301 back on the air, but I come across a problem that I can’t figure out. I have got the SSB alignment pretty much done….10Watts out( it’s

Another thing that might be done with a "stock" (9MHZ IF) '301 is to redesign the Filter Unit entirely, adopting a Jones approach such as Ten-Tec and Elecraft have done. 9MHz crystals are common and

I have 4 good TIL 308’s (right three segments) that I bought off eBay for sale if anyone needs some. Gene N4FZ

Hello everyone, like some others here, the FT-301 line was an object of desire early in my ham life. I owned a FT-101E at the time (still do), but the FT-301(D) always was the best looking radio -

Greetings Dave. Last time I was in the UK I was working in a funny looking round building in Cheltenham. Enjoyed my stay working with scary smart UK chaps. The FT-301 is well designed. The ETON Swiss

Hi Rex and other members. I fancied a 301 back when they were new, but with a family and mortgage the money wasn’t available then. Anyway I have just picked one up at a junk sale so it’s going to

Well, It was the filter. I did not seem to have any problems with the passband, but it must have been lossy. I put in a spare XF-92A that I had laying around and it seems ok now. I can get good

Randy: All audio board caps new and no problems setting carrier points. Even if the filter was jacked, I was certainly able to get the carrier in a good spot for testing. I did do the carrier point

Give full output in CW is now gets complex. Yeasu never supplies levels, anywhere. My guesses: 1. Audio board capacitors, level out to IF board low.. 2. IF filter cocked up, were you able to set the

Rex, Yes, I have tried a peak reading wattmeter and verified that I do not get more than about 15-20 watts peak when speaking about 3 inches from the mic (mic gain at max). With mic gain controls at

You probably already know this but just in case and a reminder for others;? Are you using an active circuit true peak reading (pep) wattmeter to monitor the output of the 301?? On a regular

Does anyone have a 301 that does not require all mic gain controls to be maxed out and close talk the mic to even get close to full output? I have been struggling with this 301 since I got it trying

open your web browser to? ? translate.google.com then enter the web page address https://shop.elcon.ch/yaesu/frequenzanzeige-modul-_yaesu-ft-301d-pb-1542-ersat.htm

You have to open it in Chrome and may have to choose something at the top of the tab to translate

How do I change the web site to the English version?

Hi George I have many modifications for the FT-301D on my homepage. https://shop.elcon.ch/yaesu/frequenzanzeige-modul-_yaesu-ft-301d-pb-1542-ersat.htm You have to scroll all the way down for the