开云体育

Thank you. Fingers crossed

I agree with Fred….you are almost within the normal tolerance with that.

Hi Ed. I would think a 33uh should be fine. Fred

Does anyone know a suitable replacement for choke L2?? I have a radio that I am trying to repair that has one that is burnt. The parts list in the service manual lists it as a 35 uh choke with a

Hi Andrés, Thank you for sharing the manual. Michael

Estimado, estos son los dos manuales que yo he encontrado + esquemático completo Saludos CE1AVF

Vielen dank Roland. Bob

Hi Bob There is a new firmware update version 2.1d for the frequency display. This can simply be uploaded to the display module via USB. You can find the function and operating instructions here

This FT-301D is still being offered for sale.? I realize shipping is more expensive so I am willing to negotiate the deal.? It is boxed and ready to go.? See pictures in earlier posts.? Remember,

Thanks Bob. Private message sent. -Jim

Pic of radio and filters (all three). <robertisselhard@...> wrote:

Jim:? Thanks for your interest and questions. I will get some pix posted later today after I go out to the ham shack and turn the radio ON. I don't have a hard copy manual.? I d/l a .PDF off the

Hello Bob, If item is still available, I am mildly interested. If you can send/post a couple of pics: front, back and top, we could start with that. You don't mention a manual or if there are any

Well Chuck, since I have no mic for it, I don't know about AM.? And I didn't try it on CW.? If you have confirmed yours doesn't xmit on those modes, I suggest you look at the IF UNIT, specifically

I was given a FT-301S with a similar symptom... generates RF on AM but not CW/SSB. Different modulation circuitry for AM. If this is a frequent problem, I'd love to get a hint where to look. 73 Chuck

I have an FT-301D for sale.? It receives all modes all bands.? This one has an 11 meter crystal in the AUX position? I have the original Yaesu power cord and plug but no microphone.? I see power

200 watts! Sounds impossible. Better check your watt meter is calibrated!

Hi, I would verify that your watt meter is reading correctly. Try another watt meter. Are you transmitting into a 50ohm dummy load? What type of power supply are you using? What is your DC voltage /

Hello everybody, My FT301 has an HF output of 200W on all bands... I suppose that is not normal. When i reduce the drive? (at half on the pot) the power goes down to 100W Is there an alignment to do?

Maybe this link helps https://www.tedss.com/2025009004