开云体育

Hi All, I'm currently testing Yaac with Robust Packet on HF, and it would be most useful to be able to Center automatically to the last station heard.on the RF port. I've looked in the documents / FAQ

It looks like all is ok now, doe you agree? Joe Sent: December 9, 2023 11:39 To: [email protected] Subject: Re: [yaac-users] YAAC wont digipeat Thanks Andrew. That was the problem. Too much data in

Thanks Andrew. That was the problem. Too much data in this old head and sometimes it gets lost. 73, de Ian VE3EP ________________________________ Sent: December 8, 2023 5:31 PM To:

On your RF port (AGWPE or Serial_TNC), which digipeat aliases did you choose to be used on that port? Digipeating doesn't happen automatically on every RF port; it has to be configured on a

I googled it and found I could easily install JRE with $ sudo apt update $ sudo apt install default-jdk I checked that all was OK with $ java --version -- -- Bill AA6BD

I must have changed something, but I don't know what. The following is set under the digipeat tab: ALIAS ??????WIDE 1-1 checked ????????????WIDE 2-2 checked

And you notice both of you said "Raspberry Pi 3B+", not "Pi 1A" or "Pi Zero". That was an annoying "feature" that the Raspberry Pi Foundation (or whoever manages the Raspbian distro) built the newer

Compiled perfectly here also on Raspberry Pi 3B+ running Bookworm 64: uname -m aarch64 Jerry

Works fine on an RPi 3B+ with Debian 12 here: $ uname -m armv7l $ wget https://www.ka2ddo.org/ka2ddo/YAAC.zip --2023-12-05 12:26:31-- https://www.ka2ddo.org/ka2ddo/YAAC.zip Resolving www.ka2ddo.org

Error messages can sometimes be rather arcane, but they are always indicative of the problem.

Michael. Your experience and findings are indeed valuable.? I suspect many will, if not have already, hit that issue, and many will just give up. I for one appreciate you documenting your struggle.

I was setting this up on an existing RPi system. At the time, when I started, I was unaware of specifically which model of RPi I was using. It was in a case that was difficult, and, at the time,

So why do you expect results on armv6l,when it "clearly" states that armv7l is required? I'll agree that the case insensitivity may cause confusion.

As mentioned in the original post. pi:~ $ uname -m armv6l Michael Rusty Travis wrote on 12/4/23 4:35 PM:

What does "uname -m" return, compared to what's *_boldened_* above?

Trying to install YAAC on a Raspberry Pi for my RV, followed website instructions and get the following error: michael@trailer-pi:~/YAAC $ java -jar YAAC.jar Error occurred during initialization of VM

Most likely Option 2. As I-gates go, YAAC is very slow, because its prime focus is to get the information on the screen for use by the human operator. So, if any other (non-YAAC) I-gate heard the same

Option 2. James VE6SRV

I have my station setup to "Allow RF -> IS gating" and I have ports setup for both RF and IP, and both have Transmit Enabled. Looking at the Raw Packet sniffer with the filter set to packets from the

Sounds like you're running a very ancient build of YAAC. That provider API version dates back to mid-2021; are you at build#165? The current build is #191. I recommend you upgrade to get the hundreds