开云体育

Check menu 518 to set the baud rate for the serial port on the head unit (1200/9600). Match that with YAAC's port.

More info, When I create a port and click on test all I get is a blank window. The RTSystems cables are working as I can communicate with the radio when using the RTSystems software. I am at a loss so

The D710 actually has 2 data ports. The one on the base allows for memory programming and the one not the control head connects to the tnc. I’m beginning to think though this might be a permissions

And, as Danny pointed out, the D710's TNC is in the control head, not the transceiver body. Connecting a serial interface to the transceiver body will not be able to access the control head's TNC.

Right, that's what I said. 73 Danny, K5CG HH 550-0609 SKCC 14257

The D710 has a built in tnc.

Yeah, here it is. /g/yaac-users/topic/88474657#msg1319 73 Danny, K5CG HH 550-0609 SKCC 14257

Oh I could be mistaken. YAAC could talk to the D710 if you connect the serial cable to the head unit. 73 Danny, K5CG HH 550-0609 SKCC 14257

YAAC doesn't connect to a radio. YAAC connects to a TNC (direwolf/soundmodem). The TNC connects to the radio. 73 Danny, K5CG HH 550-0609 SKCC 14257

Hi, I am trying to configure a port through yaac to my Kenwood D710 using an RTsytems cable. No matter what setting I choose I cannot communicate with yaac. The RTsystems software works fine, I am

That's what I did too. The digirig would provide PTT for you but again, you would end up connecting that to the PTT of the DATA port and you'd be sacrificing the other half of the radio as unusable.

Hi Danny I have been absorbing all the information that you and others have provided and have decided to emulate your situation and forget the digirig (unfortunately because it was expensive hi hi).?

If you want to make your own cables, this is what you need (drawing modified from the manual). The Serial port can go through a DB-9 connector to a USB Serial port DB-9 or you can use a USB to serial

You can use a GPIO but it is a terrible idea. If you PTT this radio with the PTT input on the DATA port then it will key the radio on whatever side (A or B) is active. If you use a serial port and the

With that particular setup, the DB9 connector had audio ground, Tx audio, Rx audio, and PTT on it (see the TNCPi docs for the pinout). So you need the audio connections to your USB sound card, and the

Hi Danny I already have a homebrew cable with a miniDin on one end and a DB9 on the other. This was from my old tncpi2. In the old setup, the miniDin plugged into the Kenwood radio and the DB9 into

Yes Joe, that will work. Now you need to connect that to the radio body by making the cable or with a Kenwood PG-5H cable kit. Connect the sound card jacks to the USB sound card. The DB-9 data goes

OK thanks Joe ________________________________ Sent: November 30, 2024 20:26 To: [email protected] <[email protected]> Subject: Re: [yaac-users] YAAC and Direwolf interfacing No, it's a standard

HI Andrew and Neil With Direwolf running, I can create the yaac ports. I still have to connect to the radio but this is great progress. I have to purchase several audio cables. I can't believe I do

Sorry I fat fingered that. I meant to yaac. I’ve got it all working now though.