开云体育

[pcbgcode:master] New Comment on Issue
By :

I'd like to vote for the "Spot Drill" First Hole / Remaining hole fix. It's always catching me out!

Regards, M.

[pcbgcode:master] New Comment on Issue
By :

I finished my PhD,

Congrats! ?? Harry

[pcbgcode:master] New Comment on Issue
By :

I'd like to vote for a "Spot Drill" First Hole / Remaining hole fix. It's always catching me out!

Regards, M.

[pcbgcode:master] New Comment on Issue
By :

Thanks!

[pcbgcode:master] Issue closed by .

[pcbgcode:master] New Comment on Issue
By :

I'd like to vote for a "Spot Drill" First Hole / Remaining hole fix. It's always catching me out!

Regards, M.

Could you open an issue for that with a description? I regret that I’ve lost track of issues and contributions people have made.

[pcbgcode:master] New Issue Created by :

I'm trying to use PCB-Gcode in Fusion 360.

I have installed PCB-Gcode 3.6.2.4 it into the same directory as the rest of the ULPs.

The good news is that the "pcb-gcode-setup.ulp" works fine.

However, when I try to run the "pcb-gcode.ulp" program, I get the following error message:

**/Users/jim/Library/.../examples/ulps/examples/pcb-gcode.ulp(1387):

polygons loop is depreciated.? Use polyPours polyShapes polyCutouts instead.**

Is there a way to fix this?

[pcbgcode:master] New Issue Created by :

I'm trying to use PCB-Gcode in Fusion 360.

I have installed PCB-Gcode 3.6.2.4 it into the same directory as the rest of the ULPs.

The good news is that the "pcb-gcode-setup.ulp" works fine.

However, when I try to run the "pcb-gcode.ulp" program, I get the following error message:

/Users/jim/Library/.../examples/ulps/examples/pcb-gcode.ulp(1387):

polygons loop is depreciated.? Use polyPours polyShapes polyCutouts instead.

Is there a way to fix this?

[pcbgcode:master] New Issue Created by :

I'm trying to use PCB-Gcode in Fusion 360.

I have installed PCB-Gcode 3.6.2.4 it into the same directory as the rest of the ULPs.

The good news is that the "pcb-gcode-setup.ulp" works fine.

However, when I try to run the "pcb-gcode.ulp" program, I get the following error message in Fusion 360:

/Users/jim/Library/.../examples/ulps/examples/pcb-gcode.ulp(1387):

polygons loop is depreciated.? Use polyPours polyShapes polyCutouts instead.

Is there a way to fix this?

[pcbgcode:master] New Comment on Issue
By :

Hi M.! You might try the fix from Alexander Arkusha explained on my . The fix is described as second topic on this page.

Please keep an eye on the line numbers, perhaps you and I refer to different vesions of pcb-gcode. But given the context, you will find the correct lines, where to change the code.

Harry

[pcbgcode:master] New Comment on Issue
By :

Hi M.! You might try the fix from Alexander Arkusha explained on my . The fix is described as second topic on this page, starting with "A further improvement over the original version was suggested by Alexander Arkusha in the end of 2017."

Please keep an eye on the line numbers, perhaps you and I refer to different vesions of pcb-gcode. But given the context, you will find the correct lines, where to change the code.

Harry