Keyboard Shortcuts
ctrl + shift + ? :
Show all keyboard shortcuts
ctrl + g :
Navigate to a group
ctrl + shift + f :
Find
ctrl + / :
Quick actions
esc to dismiss
Likes
Search
Eagle 8.5 with #PCBGcode 3.6.2.4 issue
#pcbgcode
|
Jos¨¦ Luis
After a long time to rest, I had try to make a small board, and I found an error that never found before: When type run pcb-gcode an message appear: unable to open the include file source/pcb-gcode.h. Perhaps its my mistake, but now I can?t see where it is. Can you please help me on this? Thanks in advance. My best regards. Excuse my poor english! |
¿ªÔÆÌåÓýJose,Sorry that no one else has attempted to help you, but in the cobwebs of my mind, this might be due to proper setup.? First off, I do NOT use V8.5 so I may be way off base. However, when you set this version up, did you follow the docs to put the proper file paths in 'Options'>'Directories' ?? As I remember from years past, this might be the solution? Good luck. Country On 5/24/2023 6:49 AM, Jos¨¦ Luis wrote:
|
|
?
On this page (http://chilipeppr.com/jpadie) you can directly import the brd from the Eagle program and send it to your cnc. There are many settings for DPS with Eagle.
______________________________________________________________ Sorry that no one else has attempted to help you, but in the cobwebs of my mind, this might be due to proper setup.? First off, I do NOT use V8.5 so I may be way off base. However, when you set this version up, did you follow the docs to put the proper file paths in 'Options'>'Directories' ?? As I remember from years past, this might be the solution? Good luck. Country On 5/24/2023 6:49 AM, Jos¨¦ Luis wrote:
|
to navigate to use esc to dismiss