开云体育

I am not sure of your question. Not having a smoothstepper, I have no idea of how it would be connected there. I use TurboCnc and there is a port pin dedicated to the probe. It has a pullup resistor

Hi, I have used Autoleveller for five/six years and could not realistically do the work I do with the machine without it. With the PCB blank double sided taped down to the spoil board the uppermost

I have a smoothstepper with a probe i/o so I'll try something like that but where is your circuit attached?

My "Probe" for this purpose is my 'engraving' tool. I chuck it up in the spindle and alligator clip one side of the probe cable to it and the other side to the pcb stock *which is insulated from the

Art, what do you use for a probe?

I use double-sided sticky tape to hold the boards down. As the boards are not too big, I usually don’t have a problem with leveling. I can mill tracks down to 12 mils wide and usually get +/- 1mil

@Art, Yes, my system doesn't cater for a leveling mesh or height probing, only one spot to zero Z and the rest based on the material being perfect. For wood and aluminium etc, it is fine but PCBs, no.

When you say "because the software and controller don't cater for that" do you mean you can't do probing or what?? I find leveling software such as <http://www.autoleveller.co.uk/> in valuable because

Hey guys, So I have basically shyed away from milling boards and just buy perf board and this is why; I can't do a levelling pass with my machine because the software and controller don't cater for

Sorry that I forgott to mention that my directory listing is using o.s. environmental variables. I have used this configs successfully for a number versions(years) including on XP. I don't remember

I'm not sure about that. Personally I just open a finished file in Mach3 and check the files integrity, visually there.

Thanks, I used the modified version it said "keith3125" and it works. I also set up the directories as you indicated. Only a minor problem remains, within the setup screens the images are not

I had trouble with issues relating to using Win 10. I downloaded this modified version and worked beautifully with 9.6.2.Keep in mind that you need to make sure wherever you put this ULP is where you

Pcbgcode install folder should be in the “User Language Programs” table which you can find in: Eaglex.xx > Options > Directories *** As it is highlighted on my system *** Sent: January 2, 2021

Hi, OK, flying blind here as I am not using Eagle V9.6.2 nor am I using 3.06.0.4 (which I don't even have a copy of), but will start off with asking a dumb question: Have you configured Eagle

Inside Eagle ver. 9.6.2 when I run "pcb-gcode Setup" version 3.6.0.4 in the "GCode Style" window no style appears and if I click on the "Accept" button the system responds with an error "Can't open

Hi all- I've had some nice results recently that I thought I'd upload pictures of, but...for the life of me I can't figure out how to create an album and/or upload photos! All I have been able to

I'm contributing to a discussion thread that's been dormant for almost a couple of years, so I'll start off by summarising the problem. Some folks find that pcb-gcode doesn't spot drill on the etch

Trying to install PCB-GCODE in a legacy Eagle (6.6.0). Getting attached error. *

I'm beginning to do more double sided boards. Until now I was able to do everything with a single side with maybe one or two jumpers to clear interfering traces. I still want to hold the number of