¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: How to etch a powerplane with pcb-gcode? #etch


 

You could look into doing a polygon with a crosshatch fill pattern, with the pattern spacing smaller than your endmill size. Been a while, so I¡¯m a bit rusty on the details.
You could also just draw a grid or stripes on the milling layer.

Regards,
JJ


From:?Fred Genius <fredgenius@...>
Reply:?[email protected] <[email protected]>
Date:?November 25, 2018 at 3:26:01 PM
To:?[email protected] <[email protected]>
Subject:? Re: [pcbgcode] How to etch a powerplane with pcb-gcode? #etch

A 1/8¡± end mill has the same size shank as a V bit (typically), so perhaps more convenient than a 2mm or 3mm bit. Although ER11A collets are designed to close up 0.5mm, I found it somewhat difficult to get a 3mm shank tight in a 1/8¡± collet..

?

Fred ???

?

From: [email protected] [mailto:[email protected]] On Behalf Of Christian Robert Adzic
Sent: 25 November 2018 20:20
To: [email protected]
Subject: Re: [pcbgcode] How to etch a powerplane with pcb-gcode? #etch

?

Thank's guys!

One of these solutions will solve my problem.

I think also does engraving a large area of copper with a V carve bit will take too much time.
I will use an endmill?bit 2-3mm.

This situation is not a common?situation so a bit coding in gcode?would be fine I assume.

Thank's all of you.
My best regards.

Join [email protected] to automatically receive all group messages.