开云体育

Charlie Sorry if you have done so, but with all, you have checked and I am out of ideas, I need to ask. Have you loaded the Dashboard Pallett's into your Window Node-Red install? Alan wrote:

Dave: While I have the meters in for the 6400's flow zeroing fine, the same isn't the case for the 3000. I can't figure out the GATE node....Can't find any examples that don't just show the pasted

Tried it on a different computer.....same result. Charlie

Also, if clearing the browser's Cache does not allow you to see the Dashboard, can your try another browser? ?Or, even a different computer? Alan

Charlie Clear the browser's Cache. Sometimes it does not get updated correctly from Node-Red. Alan wrote:

Alan: I was just testing it with a simple flow unrelated to the Flex.? When I go to? 192.168.1.xxx:1880/ui , the browser just shows a blank page. Yes the node red cmd window is still open. It can't

Thanks Alan Sent: Thursday, February 25, 2021 12:09 PM To: [email protected] Subject: Re: [nodered-hamradio] Alexa Node-Red interface Hi Dave I need to be careful my iPhone does not see me

Hi Dave I need to be careful my iPhone does not see me responding. ? Anyway, here is a UTube video that may assist you. Tube Alexa / Node-Red ( https://www.youtube.com/watch?v=sv0MJYLcWPk ) Alan

Does anyone have experience with using Alexa to control a node red flow?? Thanks in advance for your input, Dave - k9uk

Charlie Perhaps Node-Red is not running when you try to see it on the browser. On Windows Node-Red you must keep the CMD window open after giving Node-Red the start command "node-red". If you close

I turned the firewall OFF and it still does not display the dashboard. I uninstalled and reinstalled Node Red and same result. Charlie

Try a different browser. 73, Marty WD9GYM

Turn OFFwindows Firewall and test. That will tell you if it is the firewall. Turn back on after the test. wrote:

I installed the Vita49 and Flex v6 flows.....it's not the TX meters.......it's only the S-Meter that goes full scale on disconnect for the 6400 I modified the function node you had in there to set the

It doesn't display the dashboard even with localhost:1880/ui I went to "allow a program to pass the firewall" and node js is checked so I don't know what else could be blocking it. Charlie

You can load the VITA49 and FlexRadio flows in addition to FRStack. 73 Dave

Works fine for me... It may be an issue with your windows firewall. Worst case, the need to open that port up. Regards Dwayne (310) 849-2036

My 6400 flow is using FRStacks. Charlie

Hi Charlie The first place I would look is to make sure that the Firewall isn’t blocking it. Mike

Has anyone tried installing NodeRed on Windows 10. I did so, and it looks fine, but the dashboard doesn't display when going to xxx.xxx.xxx.xxx:1880/ui. The browser window has "undefined" at the top.