开云体育

Good morning friends on this cold Christmas eve. My Stream Deck Frequency Entry flow, written by Alan, was not working so I deleted the old one and installed the one from the files section. If you are

Freakin' great document! Thanks and best regards to all for the holidays! Neal K3NC neal@...

Thought I'd share some my experiences with setting up the ser2net service on my raspberry pi to act like a USB/serial to network media converter. I installed the ser2net service with one command :

Al My bad for not looking. ?Yes....yours is dynamic. ?I loaded it and took a look with my single radio. ?Looks good! Alan

Alan, ? This? it the dynamic node version and work very? well thanks to your nodes. AL, K0VM

Thanks, Al Yes, I knew someone had made a gate-based client selector, but I could not recall. Bret has installed my Dynamic Flex Node version and reports it works very well. If you get a chance, could

Alan, ? My flow? is at /g/nodered-hamradio/files/%211%21%20Flows%20by%20Type/RADIOS/K0VM%20Flows/Select%201ofN%20Flex%20radios AL, K0VM

Alan, ? Here is what my Flexd radio selector looks like. AL, K0VM

Just a thought, if I start NR then open SmartSDR , the flows only show connected, the client (my call) does not work. I do a refresh on the browser and NR restart , still no good windows 10 . But if I

Yes I will try this evening west coast time zone :)

I need help testing a new Flex Radio Select Flow. Previous Flex Radio selectors used gate nodes to switch the Flex Connection nodes and the Discovery Packets, with each manually configured. I took a

Looks like your flows is expecting a line feed on input as Chris mentioned. Taking a look at the manual for the controller it appears you send a two byte word and get a two byte answer, so you might

I'm not sure, but here is a thought. Is the serial receive node waiting for the split char? It looks like '\n' is configured but the protocol doesn't send a newline.

I've been working on this WA4MCM controller and have a few issues.? Hopefully someone can help me.? After installing a new USB port on the back of the unit and the PI actually seeing the unit, now

Thanks Alan?for the reply.?However the same happens with version 5 at Timon, PA1T. I upgraded to see if that would solve the problem. it did not. Donor youngsters this problem with the stream deck

Thomas StreamDeck v6 has been reported to not work with some custom plug-ins. I downgraded to v5.3, and all is good for me now. Alan. WA9WUD

Hi, We are having problems with the combination Stream Deck XL and Node Red on a Raspberry Pi 3b. We like to use the Stream Deck to select beverage receive antennas and a 9 circle array. The Raspberry

Thanks Dave Great video. I added it to my site so I can use it again. 73, VE7TIT Shanta

You are welcome! 73 Dave wo2x

I am new to NodeRed just a few days and have my HyGain Rotor EZ-Rotor working in a dashboard.?? Thanks to contributors.??? I was able to follow your video and resolved how I would identify my