开云体育

Thanks Alan?for the reply.?However the same happens with version 5 at Timon, PA1T. I upgraded to see if that would solve the problem. it did not. Donor youngsters this problem with the stream deck

Thomas StreamDeck v6 has been reported to not work with some custom plug-ins. I downgraded to v5.3, and all is good for me now. Alan. WA9WUD

Hi, We are having problems with the combination Stream Deck XL and Node Red on a Raspberry Pi 3b. We like to use the Stream Deck to select beverage receive antennas and a 9 circle array. The Raspberry

Thanks Dave Great video. I added it to my site so I can use it again. 73, VE7TIT Shanta

You are welcome! 73 Dave wo2x

I am new to NodeRed just a few days and have my HyGain Rotor EZ-Rotor working in a dashboard.?? Thanks to contributors.??? I was able to follow your video and resolved how I would identify my

I have been working on a flow to adjust the AGC Threshold setting automatically. I followed Tim's paper on the topic: https://www.flexradio.com/videos/flex-6000-receiver-tuning-how-the-agc-t-works/

Maybe this will help you. Here is my ser2net.yaml config file in /etc/.? in the connector line, I just used *nr* 8001 to say designate node red is sending to port 8001.? I think you can have any

HI Dave I am sitting here with some problem whit ser2net there will not recognize my usb port ?? a new version of net2ser need a YAML config file and that is out of my range to figure it out ;-) sadly

The EA4TX boxes probably do not have genuine FTDI chipsets in them. Either a different chip that does not have unique serial numbers or Chinese clones of FTDI. This is an issue with some USB to serial

Thanks to Dave for putting out that video.? I'm going to use it on my RCS-4 replacement flow I'm starting. ...but another question now has emerged on another project that I did some digging around

Hi All, I did a quick YouTube video on how to change the default FTDI based USB serial node name from /dev/TTYUSB0 to the path by ID name which includes the FTDI cable/device serial number. This is

I did a quick video I am posting to YouTube. See my other post in the group here for the link 73 Dave wo2x Sent: Sunday, December 18, 2022 7:05 PM To: [email protected] Subject: Re:

We can do a quick Zoom if you like. I’m heading in the hospital early Tuesday morning. Let me know if you have 15 minutes and when. It is straightforward but quicker to just show you on Zoom. 73

Thanks Dave, I think all the subjects are in chapters for your videos.? I'll take a look to see if I can find it. Kyle

Windows will remember and reserve the com port number for FTDI chipset USB devices based on the serial number in the chipset in the FTDI USB interface. In Linux as a default the TTYUSB ports are

Dave, I'm putting it together now, the tower goes up in the spring. ?I also want to control the radio, amp, and tuner in the shack. That looks easier than discreet relays for the antenna switch. Tim

Oh, had no idea.? Not that familiar with USB devices and linux and how they are addressed.? Thanks for the tip.? I'll do some googling. Kyle

Hi Tim, Are the SteppIR, rotor controller, and antenna switch all located at the tower? Do you have anything else in the shack that needs to be connected to Node Red (not including network)? If so,

Lower DB9 connection. FTDI chip based serial to USB with a null modem cable. Be sure to use an authentic FTDI based cable for trouble free operation. My SteppIR flow is in the group file section. Alan