开云体育

After the uninstall, I rebooted it.? Then in user settings, searched for node-red-node-sqlite and it says it is still installed.? So, I can't install it via the GUI.

Thanks for your help, Kyle. Can I ignore these warnings on the uninstall?: pi@raspberrypi:~ $ sudo npm uninstall node-red-node-sqlite npm WARN saveError ENOENT: no such file or directory, open

I would remove the sqlite node and reinstall.? You might need to remove the sqlite node manually via the command prompt.? I think all the nodes in Node Red are installed though the npm manager. I

Yes, everything was done from the Pi login.? I did the reboot but get the same error message.? Also, on user settings, under nodes tab, on the node-red-node-sqlite node, it reads "MODULE_NOT_FOUND"

Jon, I've never seen that error before, so I'm going out on a limb here, but you installed Node Red and installed sqlite back end server under the same username, correct? I would do a reboot of the Pi

Hi George, I’m late to the party on this conversation. Been hectic here (and they say you relax in retirement). In the future use the debug node liberally to look at data at every point in the flow.

I created a new project and cloned https://github.com/kylekrieg/Node-Red-Contesting-Dashboard.? I get an error "flows stopped due to missing node types" sqlitedb and sqlite.? In manage dependencies

Hello, any one using node-red flows for?Denkovi 16 port relay board & intellinet 8 Port Intelligent PDU ? http://denkovi.com/smartden-iot-mqtt-ethernet-16-relay-board

I looked over the flows again today. I found a spot in one of the first flow function nodes that was set to flow.get instead of global.get. For some reason it worked for a while...? After changing

Thanks, Bret It would be easy enough to add Antenna information to the Tuner Sweep Dashboard, but for now, I think it would take away from the Tuner Sweep's KISS approach. ?Dave, what do you think?

This looks very good indeed and really takes advantage of the Capabilities of the Tuner Genius and a huge thanks to you Alan and Dave. I was thinking maybe if there was a way to add the Antenna Genius

Added the WO2X modified "Skinny" Bar Chart and made it the default chart. ?The "Fat" Bar Chart is available but not wired in: Also, on the Tuner Sweep, added a display to show "Tuner Solution"

The following files and folders have been updated in the Files area of the [email protected] group. * /!1! Flows by Type/SVG Based Flows/SWR Sweep.json (

Thanks Mick, My issue is the other way around. My Node Red function is sending the Non Numeric to the MOAS II server. I will try adding the node.status anyway to see what is being sent instead of the

George, It sounds like the MOAS II server is not sending the numeric data the function is looking for.? ?Even if you set it to a default number then server may be overwriting the variable with NaN

Hi, I worked on a couple of flows a few months ago that have been working pretty well. They interface with my YCCC MOAS II switch and N1MM UDP packets to show me the available antennas for each of my

Alan and I are continuing to tweak the Auto Tune flow (it is more than just an SWR sweep at this time). Alan is adding ability to show a success/fail for each tuning memory when performing the auto

Email sent to the address on your QRZ page

This would be amazing! Thank you. I'll send you a message. 73

Also, another important note on building the HTML string. The "SWR Meter" function builds a text file called, "msg.template" to send the HTML to the Dashboard Template Node. In order to get the