开云体育

Sorry, I meant to write BAND next to MODE. Yes, it works, shows DIGU. My goal is to see for example: VFO: 7.074 BAND: 40m MODE: DIGU ______________ 73 de Santiago HI8SMX web: www.hi8smx.online (

When on data modes it should show DIGU, DIGL, or RTTY. Dave wo2x

Done. Nice update for the flow. I have been looking for the document where I can find all Flex strings and messages. I found some wiki but havent seen anything there. For example, how/where do I

Oh, you need to click on the three horizontal lines in upper right corner and go to Manage Pallette. Click on install and search for node-red-contrib-string and install it. Reboot the Pi I am going to

I imported the flow, but Im getting an error in the following string: ______________ 73 de Santiago HI8SMX web: www.hi8smx.online ( http://www.hi8smx.com ) YouTube: HI8SMX Twitter: @hi8smx Instagram:

Yes. I have cleaned up some of the parsing and in addition to TX Frequency I now parse the current TX slice RF Power, Tune Power, and Mode. There are global nodes to send TX Frequency to other flows

The following files have been uploaded to the Files area of the [email protected] group. * /wo2x flows/W2wattmeter.json ( /g/nodered-hamradio/files/wo2x

Good afternoon all! I’ve been held back on node red due to work and a family trip. I don’t have a W2 meter (yet), but the new Flex flow worth looking individually? ____________73 de

OK. I have finished the tweaks to the W2 wattmeter flow and the FlexRadio flow that is required to match it. I have added some parsing of current band TX power slider, tune power slider, and current

This is GREAT info and thanks for the Info 73's Bret WX7Y

Bret That is an MQTT Broker Out node. The MQTT out node allows the flow to send the Flex TX status to a different Raspberry Pil Not applicable to you unless you have a second Pi you want to receive

I have a question on a Nodes, in the NEW "FLEXRADIO" Flow it uses the IP and Port number of "192.168.50.134:1883" and always says "connecting", If I put my FLEX Radio IP in here it still says

Bret Your welcome. Glad to help I know Dave is close to releasing an update for the W2 that will further improve its reliability and functions. Alan

Kevin Can you run multiple flows on one Pi - Yes, there is no limit.....well I suppose there is, but it would be higher then I could ever get to. The breakout boards and relays come in many flavors.

Hi Dave, Just wanted to comment on things thus far and Thank you so very much for your help and debugging and Building the Flows!!! Between you and Alan have built my whole automation for my remote

All, What break out board or relay board do you all suggest I purchase? I already have a couple Raspberry Pi 3s. I have a Flex 6400 that I leave powered up all the time but I was thinking my first

I would like a board to experiment with if you have any left so put my name on 1 of them if you would and let me know the cost to ship WX7Y Bret Mills

Tracked the error was coming from the Flex radio Flow not running ver 3 right now because of another issue I'll give you a call in a few minutes Bret WX7Y wrote:

Hi Kyle, Good to have you on board. I have my flows up on the file section of this site /g/nodered-hamradio Take a look around and see if any of the flows work for your hardware. I am

Just putting out a post to prove I'm not a bot! I have a Flex 6700 remote with a Pi that I use to tunnel ports back to my local station control and I've known about Node Red for a while, but haven't