开云体育

My experience is that it is best to specify the serial port by ID This is especially helpful when using more than one serial adapter or multi serial adapter on the same Pi. It will protect your setup

Works for me using serial to USB FTDI cable.

Resending Bret. Use these settings. Instead of the TCP in and TCP out nodes, use the TCP Request Node. It has an input and an output, just substitute for the TCP in and the TCP out. Here is a

Actually I believe he will want to use serial on and out. I do not believe I have seen a serial request node. He is not using a serial to IP adapter. Baud rate should be 9600,8n,1 Dave wo2x Sent from

I’ll be available tomorrow and Alan has added a few tweaks to the W2 flow. Give me a call in the morning. I will be up since two hours ahead of you Once I verify Alan’s changes on Bret’s W2 I

You say the usb cable shows as connected. Good Linux found the USB port. Use the same USB port with the settings I sent you, and use the TCP Request node instead of the two TCP in and TCP out nodes.

Yep tried that I am now testing on the bench using the Windows App and all work A-OK, Just wondering do I have to set the COM port serial number in Linux anywhere? also what baud rate does the W2

Also, if that does not work, do as I did Instead of the TCP in and TCP out nodes, use the TCP Request Node. It has an input and an output, just substitute for the TCP in and the TCP out. Here is a

Bret- Re-boot the Pi, then if nothing, power cycle the W2 (unplug, plug back in). Alan WA9WUD

Hi Dave, Hay got the Elecraft W2 Wattmeter today and got it plugged in with the included USB serial cable BUT I am not getting anything coming out of the W2 to the FLow wonder when you have a minute

Hi Kevin, Check out my flows in the file area on this group’s site. Read the readme which describes additional nodes you need to install and how to do it. Feel free to load up one of my flows to see

I just got Node Red installed on my Raspberry Pi3 now to figure out my first project!!!!! Kevin w4kjp

I posted a rough How To in a previous message on setting up the Pi with Node Red. You can find archieved messages at /g/nodered-hamradio 73 Dave wo2x

Looks like a great group starting up. Now to get my Rpi3 running node-red! Thanks - Gordon N1MGO

Wow, we are up over 41 members. For those new members, you are in a moderated condition until you post one or 2 items so you are a real ham radio human. Thanks all Mike va3mw

Good morning all and welcome to our new members. A reminder that your first post is moderated. We have three moderators in the group so message approval is usually pretty quick. Second, archives of

Very nice looking! Tomorrow I am going to revisit the parsing of the rfpower= slider value for current TX band. I thought about it earlier and have some fresh ideas. When you do a C44|sub tx all on

Hi Mike, The Smeter flow works using data coming from FRstack. I have no idea how to decode the smeter data stream that comes from the radio direct. VITA-49 is way over my head in coding to decode the

The issue is the messages are not always the same length and the word rfpower= appears over 10 times. I need to look for a unique keyword for the portion pertaining to the transmit slice. The other

Looking forward to Gary’s Github.... Great job Gary!! ____________73 de HI8SMX?hi8smx.onlineHI8SMX on Twitter, Instagram and YouTube