I have downgrade my ser2net to ver.3.5 as the last ver is unstable and having problem to get it to start,?
when I use telnet my K3ng rotor I can get my AZ-readings out , and this is ok?

if I put a debug-note on the input I can se the command there, is ok...the command "C" is the AZ

and I put a debug-note on the output of the Ser2net, then there come no AZ readings..... :-(

the K3ng Arduino board is set to 9600 baud and also the ser2net.conf is made for 9600baud
Any one ther can give me a idea what is the problem ????
73" OZ1CT Ben