开云体育

I tried ZPLOT on Libre Office V5, no go too. 73 de Andy

Unfortunately, I have not tried to use zplot at this time but since Softmaker claims it is compatible, it may work.? On Sun, 8 Dec 2019 at 1:47 AM, pgc1682@...<pgc1682@...> wrote: Hi

My currently installed firmware allows changing scale of Smith plot, but not center. Perhaps a firmware bug in October overwrote scale and offset...

Hi Rudi The ZPlots has facilities as mentioned before to calculate Z0 as function of Frequency base on measurement of an open and shorted cable. Here is the result for the 33cm cable we are

seems like its dooable then,imworking on making a milled aluminium case for it so the mechanical stuff isnt an issue,was more concerned about the frequency responce,im only going to use it upto 70cms.

Hi Paul, if N is an alternative for you: N provides much better accurate quality for higher frequencies than BNC. See pics: The (slightly hot air bent) extended PE board permits hand isolation: Often

/g/nanovna-users/wiki/BNC /g/nanovna-users/wiki/RF-Calibration%2C-considerations%2C-notes

What Linux distribution are you using? As Nick said, if you follow the installation instructions, the program installs without a problem on Linux Mint 19.2 and works just fine.

And your badly written, ungrammatical "thoughts" are not an answer at all! If you have nothing useful to say, please avoid posting noise.

No: https://www.softmaker.net/down/officecomparison_en.pdf

If you want to move a marker, put your finger or stylus on the trace, and without lifting it, drag left or right. The important bit being "without lifting it". If you lift your finger or stylus, you

To check for newer offerings, I go to /g/nanovna-users/wiki .. then search for software .. then firmware

Hi Bob - Unmodified ST-LINK lacks support for communicating with firmware https://electronics.stackexchange.com/questions/321446/is-it-possible-to-use-st-link-usb-for-uart-communication

Why not? But i dont think they wil fit or the case wil be a lot thinker,maybe if you make a printable box around it Op zo 8 dec. 2019 09:30 schreef paul larner <quadzillatech@...>:

seems to me the vna saver is iffy,i get a smith chart with only the trace displayed ie none of the circle markings,its like the trace is in thin air,any ideas?,on my lappy the creed display just

only half an answer as per i see!!,why do ppl bother if only answering half the original question?,beggars belife so many folks on forums do this or go off on a tangent!!,just my thoughts! 73 m3vuv

hi all im thinking of changing from sma to bnc connectors on my vna,maybe mounted on an extender board hooked up to the vna with some small coax,is there any issues with doing this as regards acuracy

Hi Larry, Thanks for the tip Softmaker freeoffice. It has a full visual basic compatibilty with free version? Zplots not work on older excel, libre office and openoffice. Currently write reply from my

I have one more question regarding the NanoVNA Saver software In the TDR display there are two traces, One Red and one blue. I understand the red but not the blue. Would some please give me an

I have one more question regarding the NanoVNA Saver software In the TDR display there are two traces, One Red and one blue. I understand the red but not the blue. Would some please give me an