开云体育

I am new to VNAs, but have wondered during these past few weeks as I experimented with my NanoVNA-H if it is better to calibrate /within/ the 3 bands that use different harmonics. 0-299MHz 301-599MHz

I park my taskbar on the left, because most screens these days have lots more pixels in width than in height, and I auto hide the taskbar.This is especially useful when running several fldigi apps

No. nanovna-saver is written in python, it runs anywhere you can get python. I use it on my linux systems. Shouldn't be hard to add an interval timer to it. However, I've thought that maybe it would

I like nanovna-saver, but that runs only on Windows? And I don't know that it has an interval timer for data acquisition. -- On the banks of the Piscataqua Rich NE1EE

How about connecting a Pi or summat running *nix and Python. Not an expert w either one, but have tinkered w the Pi (and others, such as Propeller)

Hi Larry, Erik, Jim, Thank you very much for your replies, seems what I am after is possible but not as straight forward as I had hoped. Well, need to find the time to experiment a little and see how

I see that I am not the only one who wants to know how to contact developers. I looked on github, but didn't twig to the usefulness of this feature. Oristo replied to another post with this

Thanks for this tip...I have been wondering how to provide feedback and recommendations to developers. -- On the banks of the Piscataqua Rich NE1EE

Hi Rune, Could I also add a request to be able to change the size of the markers on the graphs. When larger line and plot sizes are used, it can become difficult to see the actual markers. Thnaks,

Thank you Oristo. I'm not sure how to press pause when the unit is hanging on the antenna up in the air, that's the reason I think a *scheduled *one scan+pause will do it. To clarify my request, let's

Hi Ady This is already possible using https://github.com/qrp73/NanoVNA-Q/releases Not sure why delaying start is necessary; scans until pause are discarded. Only the final scan before pause is

That works when short and open results are similar and load signal is small. Small load signal is generally easy for resistance bridge at low frequencies, not so much for reflection bridge and higher

Hi Kurt - .. and another piece of the puzzle falls into place.. Thanks ever so much!

The very "short" one port equation does get meaningfully close, but diverges with frequency. I haven't computed the impedance deviation yet, so it's too soon to pass judgement. My spreadsheet is

thank you, I made a mistake during calibration, now the reading is good, have a good day Gilles

Hi Gilles, I assume you followed a calibration routine as documented. There is one in the file directory. See

hi, When I am doing a full calibrate O S L iso and thru. I get a -10.8 dB on log mag with the RG174 coax cable. on full RF span exemple: 28 to 30MHz or other frequencies range. channel select is

Rune, While you are at it is there any way to integrate an option so that the cursor data can be displayed in the appropriate graph display area similar to the data that you see on the real VNA

GIN & PEZ@arg; New results to please you all the more. I just replaced your mini equation: https://www.op4.eu/code/G-mini.c.gza.cc.by.4.0.2019.png with your even smaller equation as presented in Part

I'm using a Dell laptop at 1366x768, font size 8, 16:9 aspect ratio, Windows 10. I haven't had problems with the scrollbars being present or overlaying the taskbar since before nanovna-saver version