开云体育

test jigs added to Wiki Application Notes /g/nanovna-users/wiki/Application-Notes

I have made a test jig for my VNA based on a ZIF socket. I always measure with the ZIF socket closed, even if nothing is locked into it. A short is literally a tiny piece of wire a couple of mm long.

When using the nanoVNA at frequencies above 300MHz it switches to harmonics mode First attached picture shows the harmonics till 1600MHz of the SI5351 output when set at 100MHz. The 9th harmonic is at

Have a look here: https://en.wikipedia.org/wiki/USB-C#USB-C_receptacle_pin_usage_in_different_modes You need to attach 5.1K resistors to ground from cc1 and cc2. Scroll up the webpage to see the pins

can anyone show the circuit and photo where this 5.1k resistor should be installed. Is it possible to install it on NanoVNA-H pcb?

Martin 5:37am #5091 Ditto for me. After I decided to ignore the irrelevant emotional content, I learned a lot from Owen Duffy.

"Some people" have good depth perception

"Some people" have never experienced familial palsy.

I have been using a fixed L and a fixed C on 3.5 and 10 MHz. Works very well in getting a quick check of calibration. Mel, K6KBE

#52 : Update : The compact SLO formula for [AnyVNA] - after /g/nanovna-users/message/5081 - 17 October 2019 /g/nanovna-users/message/5075 - 17 October 2019 by Gary

Perhaps calibrating nanoVNA THRU using an RF Active Probe, e.g. https://www.ebay.com/itm/332393676082

Hugen, If I order a NanoVNA-H today will it have the 5.1k Type-C CC resistors installed? What is the link to your Nan0VNA-H site? If someone does not have a NanoVNA with the resistors does this

Hi Perhaps the caption should have been "nanovna-saver – a premature look". I mean it is of version 0.1.0. I took a different approach than writing a blog entry, or webpage, about it, namely to

Wow - you have a lot of time to look up all of these posts!Are you going to put all this in the application notes section of the wiki? Enhancing nanoVNA by an eBay 3GHz RF bridge is interesting.

Enhancing nanoVNA by an eBay 3GHz RF bridge is interesting. Before getting nanoVNA, I considered using SDR and noise source with http://transverters-store.com/rf_bridge/rf_bridge.html eBay clone

Hi Rune , very happy for the new improvement on the 0.1.3 of nanovna-saver. Suggestions for the future version : 1 Save the settings of nanovna , start stop center number segments , sweep mode , when

Citing in messages helpful specific URLs applicable to nanoVNA (and why) has value.

Hi Rune, I still can't find my old paper notes on the subject of Cs, Cp, Ls and Lp but this Keysight document seems to be the closest to what I was looking for. Section 1 of this document

Because in my experience he is usually correct in what he says, and his blog postings lead to greater understanding of various subjects, mainly due to him challenging what others may take for granted,

A dedicated USB attachment, stripped of display, battery, and switches would be nicely light weight and efficient