开云体育

Yes 100ft Mookeef RG-8X from Amazon.

Sri? error? 73 qr0Envoyé depuis mon appareil Galaxy

Hello Robert et les amis?Je ne vous oublie pas mais impossible actuellement opération ?il gauche reprise peut être fin du mois73qro et 88 à? tous les qrasF8EZZ? joelEnvoyé depuis mon appareil

Yahbut you've already got the sweeping receivers and log amp/detectors, adding rudimentary SA functions is just code. That is why so many instruments, including from the big manufacturers, combine

It works with the NanoVNA-app software and the screen is correct. But the -saver S21 is just a scatter pattern. Help! Any idea what is wrong?

That's pretty close to 50 ft. Sure it's a 100 ft coil?

Also, for a cable that long using the 101pt scan, you need to set your stop frequency to about 70MHz to see the reflection from the whole length of the cable. So what you are seeing now may be due to

Looking at your photo your yellow trace shows S21 linear instead of S11 Linear. I don't know what revision of firmware you have but recent firmware has a Cable Measure function built in. Have you

John. Thanks for your reply. Yes I have examined 2 meters each side of center. No issues are visible. That doesn’t mean that there is no damage. I will look at return loss and characteristic

You didn't mention this but to me what you have determined is that there is something causing an indication close to the centre of your coax, have you visually inspected where the VNA is indicating

Postscript: I note that I the pictures that I had attached show a sweep from 500Khz to 200Mhz. This was a photo setup error. When resetting the stop frequency to 125Mhz, the peak moves ever so

I have experienced a sudden and unexplained increase in the SWR of my HF antenna, I suspect the cheap coax or one of its pre-installed connectors. Before I chop the PL259s and install new ones, I

Jim is right, a vector network analyzer should not be further burdened with the functions of a spectrum analyzer. Bob - N7WY

female female?? or sma to reverse sma?? a friend grilled his 13cm amp with using a sma to reverse sma (accidently) no contact ... swr sky high .. final amp went in semiconductor heaven dg9bfc sigi Am

Stan, OK, I have found the problem... And it is ME! First of all let me thank you for for explaining how to calibrate the NanoVNA; although I am well aware of how to do a calibration, it forced me to

The tiny SA ultra.....with it's 4" screen, will also measure 2 tone IMD of a linear amplifier, like imd 3-5-7....and also harmonic suppression of a linear amplifier.

Hi David, The TinySA looks perfect for my needs - wow.

Erica, Yes, these devices are indeed remarkable! Many thanks for those who design and produce the devices and their extensive software. For a calibrated signal generator (and highly functional

NanoVNA can`t change output (only 4 steps), also output depend from frequency PS yes possible use external attenuator controlled by NanVNA over Serial, calibrate it. For this need software update

What are your START and STOP frequency settings? On which bands is the antenna supposed to work? When I sweep a multiband antenna, the nanovna shows me the SWRs of all the resonances within the range