开云体育

I recommend you have a look at this guide /g/nanovna-users/files/Absolute%20Beginner%20Guide%20to%20The%20NanoVNA

I have an OG nanoVNA - about 2-1/2 years now and am thinking about updating the firmware. How do I find out the hardware version number and the firmware version number for my unit? I would like to

Yes, use the x64.zip file. No need for the source zip file. Extract the zip, then click on the exe file to run it. Your older firmware should be fine; you only need newer firmware if you want more

Roger, Thanks for that info - I did have the right page but guess I didn't wait long enough fo the program to load. I should use the .64 program, since I have Win 10 as my OS, correct? Also, do I have

This is the official NanoVNA Saver github release directory https://github.com/NanoVNA-Saver/nanovna-saver/releases/tag/v0.4.0 When you start it you will get a black command box. Be patient It will

For most of today I have been searching for a nano saver offering that works with my SAA-2N and that will actually download. I've seen lots of github lists of programs with no ".exe"in the program. i

Yes, you always calibrate at the very end of the cable you are going to use then..

Thank you DiSlord for helping realize my mistake. I was inputing the stimulus frequecy and instead of pressing the M, I was pressing the x1. 73, John - W7OTD

Thanks again for your help

For a rough and ready cal, for the open, just don't put anything on. For HF, there's not a lot of difference between a connector that's open, and a connector that's missing. It's the short that you

And maybe use fw from dislord... Am 18.06.2022 10:18 schrieb Hugen <hugen@...>:

I am sure it will all work out with a little bit of patience.

If you have any further questions, please check out my website. You may find new information. -- Gyula HA3HZ ( http://ha3hz.hu )

Mike, I'm glad you managed to 'speak' the device. I’ve been monitoring things since the release of NanoVNA and trying to describe this on my web page. Unfortunately, I can’t answer everyone’s

You can use the NanoVNA-App or NanoVNA-saver. https://www.zeenko.tech/saa2

On Stop frequency input you use x1 (input as Hz, not in MHz), so input result 7.3Hz, NanoVNA not allow set this value and set minimum 800Hz Start value less then 800Hz, so and Start value also set to

Hi , some time ago , I solved the proble forcing the installation of the ST driver . Go to location of you have installed the DfuseDemo programa like this on my PC C:\Program Files

That sounds great. Should I put the short cable on for calibration since it will be on for all testing that I have planned?Sent from my Galaxy Tab? S2

Mike, You can just leave the connector empty instead of using the "open" standard. There is very little difference at 1500MHz and below. (This assumes you are using the normally supplied standards

YeeHaw! I finally got that rascal updated and seems to be working right. Now just have to wait for the open calibration cap to get here to calibrate and test some antennas and coax.Sent from my Galaxy