开云体育

Thanks John, will do. Mike C.

I recommend using the recommendations from http://nanovna.com , and using one of the vendor links on the "Buy a NanoVNA" page. That's what I just did , and bought H4 from R&L Electronics. (Ordered via

Miike, Try: /g/NanoVNA-V2 and /g/NanoVNAV2 --John Gord

Hi Larry, Relatively new visitor here. If there is a "specific" user group for the SAA-2N? VNA, could you please address it here for those of us who have "that" specific unit? Thank you for any help

Looking for an approved vendor (=not a clone) on Ebay or Amazon. I can't wait for the ports of Long Beach and Los Angeles to make a delivery. Some of my overseas shipments are over two months past

The SAA uses a binary programming protocol, not dfu, so I don't know what help files you are referring to.Please refer to docs that reference the SAA series of devices specifically and refer to the

So I have spent quite some time trying to get the SAA-2N to connect to my PC using a number of different help files. None of which worked. There are a number of missalignments to what the help files

Hello Bruce ans all, few days ago I has purchase a nanovna(SAA2) Version 2.2 and install nanovna-saver 3.8 and when I start it sugest to update to version 3.9... When I try to run it I get the same

Hi Gyula ... Tryied to visit your web page .. but the language doesn't switch to english and remain in Hungarian all the times .... Peter...

This is the place *Sent:* Friday, November 26, 2021 at 9:13 AM *From:* "davebb123456" <davidbrowne76@...> *To:* [email protected] *Subject:* Re: [nanovna-users] LIBRE VNA Yes here you go,

Yes here you go, Thanks Dave [email protected] wrote:

Does a user group on LIBRE VNA exist? Regards Piero, I0KPT

Hi, I will be brief on the answer, but you will find a lot of information in this forum in the wiki and files folders. When you log in to the forum, you will find it in the menu on the left side of

Calibration, Compensation, DIY Parts Hacking!...... My First Post! im new to all this so let me know if im the right page.... and i hope this helps another new user to get going faster then i

Alternatively, I present my favorite C meter. The Ballantine 520 measures capacitance from 0.01 pF to 12 uF (not a typo) in 12 ranges. It's an oldie, but a goodie. I can wave the probes near each

Just a general thought: We are not running a metrology lab. Sure, accuracy is worth chasing. But there is a practical limit to what amateurs can and should expect of affordable measurement

Screenshot/graph of 8 pF capacitor was missing in last post. Roger

I think you misunderstood me. My comments about high reactance were an answer to the question posed by Joe WB9SB. I said... I did not say that the NanoVNA could not measure the minimum C of the air

It did happen to me before, try loading a calibration you have saved prior, then try to calibrate again.

Hi, I tried to connect NanoVNA-F V2 0.3.0 to nanovna-saver on Windows 10 x64. I have ST com/usb driver and device is on COM7. I connected via terminal to it and talked with no issue: ch> help There