开云体育

i don`t understand 1 variant is last firmware 2 variant - is 0.8.4.3 (Only 8kHz IF change) 3 variant - is old 0.8.4.4 (2x external freq) You not fogot reset self NanoVNA calibration before calibrate

DiSlord, Flashed number 2,? threshold set to 300MHz,? recalibrated NanoVNA-Saver,? S21 at 0 now,? R+jX? R still not shown, S11 49.85 Ohms standard? way off , Marker 1 an 3 not shown. See

DiS;lord, Flashed number 1, recalibrated in NanoVNA-Saver, still no good, see picture Jos Op 27-4-2020 om 22:15 schreef DiSlord:

What is the approximate cost of the device?

Please not use old calibration, recalibrate after update

Check this 3 variants (all of them work good on my H4, try set threshold to 300MHz) Need recalibrate

In version v0.8.4.4, the level of CH1 rises after 300 MHz.

Hi DiSlord, Loaded your latest version of00000000000000 firmware 0.8.4.4 into my NanoVNA H4 and calibrated in NanoVNA-Saver. Results are not as good as in previous firmware see the pictures attached,

Erik I would like to be a beta tester. I have a RIGOL DSA1030 Spectrum Analyzer that goes from 9 KHz to 3000 MHz, a sweep generator that goes from 1 MHz to 1500 MHz, a RIGOL DS1202Z-E Digital Storage

Long read TLV320AIC3204 datasheet (unfortunately it is poorly written) Revert external freq set 96kHz mode for AIC ADC (this mode have more noise), use internal multiplier as before (i found PLL set

Hello Erik, I would like to test your spectrum analyzer. I have used an old HP 8558B to illustrate USB and LSB. However, the resolution just barely illustrates this and I have been looking for a

I had the same problem.? The H4 would not start but 1 time in 10.? and froze under computer control. I put small nylon washers on the mounting screws as spacers to keep the case from touching the

While I do have some test equipment and enjoy working on antenna I would love to get a hold of one of the units to connect it to a PC for a larger screen like NanoVNA-saver does for the NanoVNA. John

Erik, I have a pretty good set of test equipment and would be happy to test the tiny SA for you. Am particularly interested in the minimum bandwidth as someone else here mentioned to look at

Will do that tomorrow!! Thanks for the help! Well appreciated.

In 0.8.4.4 i only change IF to 8kHz Other changes only for H4 (H version can`t fast process DSP in 64bit integer, H4 have hardware support for it) PS change 96kHz mode for AIC ADC i will revert (this

I have almost any test equipment. Ready to help.

Hello DiSlord, Yes, you did up to version 0.8.4.3. Unfortunately the version 0.8.4.4 for the -H (not -H4) version is missing. I am very happy with your version, especially for audio measurement (from

Erik: I had suggested the possibility of such an item (SA with tracking gen) quite some time ago. And, while I'd be very happy to be a "tester", I imagine there are many others who would be better

I also put firmware in file folder /g/nanovna-users/files/Dislord%27s%20Nanovna%20-H%20Firmware